EasyManuals Logo

Epson EB-1761W User Manual

Epson EB-1761W
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
The details of the problem are listed line by line. The messages are listed
below.
Internal error
Fan related error
Sensor error
Lamp timer failure
Lamp out
Internal temperature error
High-speed cooling in progress
Lamp replacement notification
No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
Auto Iris Error
Power Err. (Ballast)
See the following to deal with problems or warnings.
s
"Reading the Indicators" p.98
Management Using SNMP
By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s Network - Others - SNMP p.92
a
SNMP should be managed by a network administrator or someone
who is familiar with the network.
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
The managing function using SNMP cannot be used via wireless
LAN in Quick connection mode.
Up to two destination IP addresses can be saved.
ESC/VP21 Commands
You can monitor and control the projector from a computer via USB.
Connect the device and the projector with a USB cable, and then enter the
communication commands (ESC/VP21 commands).
Before starting
To control and monitor the projector using ESC/VP21 commands, the
following preparations must be carried out.
a
Install the USB communication driver (EPSON USB-COM Driver) to
your computer. For information about the EPSON USB-COM Driver,
contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
b
Set USB Type B to Link 21L from the projector's Configuration
menu.
s Extended - USB Type B p.84
c
Connect the computer's USB port to the projector's USB (TypeB)
port with a USB cable.
Start from step 2 from the second time.
Monitoring and Controlling (EB-1776W/EB-1771W/EB-1761W Only)
126

Table of Contents

Other manuals for Epson EB-1761W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-1761W and is the answer not in the manual?

Epson EB-1761W Specifications

General IconGeneral
BrandEpson
ModelEB-1761W
CategoryProjector
LanguageEnglish

Related product manuals