e
Using the [ ], [ ], [ ], and [ ] buttons on the
remote control, or the [
], [ ], [ ], and [ ] buttons on the
control panel, correct the position of the corner.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen from step 4 is displayed when you press the [
],
[
], [ ], or [ ] button on the control panel next time. Change
Keystone to H/V-Keystone if you want to perform horizontal and
vertical correction using the [
], [ ], [ ], and [ ] buttons on
the control panel.
s
Settings - Keystone - H/V-Keystone p.82
Adjusting Projected Images
40
To Next Page
Loading...
Need help?
General
