Check Remedy
Is the
contrast
g
adjusted correctly? Adjust Contrast from the Configuration Menu.
s Image Menu - Contrast p.74
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images become darker and the color quality declines. Replace the
lamp with a new one. s p.112
Problems when projection starts
The projector does not turn on
Check Remedy
Did you press the [t] button? Press the [t] button to turn the power on.
Are all of the indicators off? The power cable is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cable. s Quick Start Guide
Check the breaker and so on to ensure power is being supplied.
If the lamp cover or the lamp are not installed correctly, the lamp will not turn on.
Check that the lamp cover and lamp are installed properly. s p.112
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector Contact List
Is Control Panel Lock set to Full Lock? Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s Settings Menu - Control Panel Lock p.52
Is the remote receiver set correctly? Check the Remote Receiver from the Configuration Menu. s Settings Menu - Remote Receiver p.76
Problem Solving
102
To Next Page
Loading...
