Extended Menu
Submenu Function
Display
You can make settings related to the projector's display.
Messages: You can set whether or not (On/Off) to display the Source name when you change the Source, the Color Mode name when you
change the Color Mode, a message when no image signal is input, and so on.
Display Background
*1
: You can set the screen status for when no image signal is available to Black, Blue, or Logo.
Startup Screen
*1
: You can set whether or not (On/Off) to display the startup screen (the image projected when starting the projector) at
startup.
A/V Mute
*1
: You can set the screen displayed during A/V Mute to Black, Blue, or Logo.
User's Logo
*1
You can change the User's Logo that is displayed as a background during Display Background, A/V Mute, and so on. s p.69
Projection
Select from one of the following projection methods depending on how the projector is installed. s p.20
Front/Ceiling, Rear/Ceiling, and Front/Pointing Down
Operation
Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
When this is set to On and the power cable is plugged in, note that the projector turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range of 1 to
30 minutes in 1 minute increments.
High Altitude Mode: Set to On when using the projector above an altitude of 1500 m.
Audio Input: When set to Auto, audio is automatically output from any audio input source.
When set to Audio1, Audio2, or Audio (L/R), audio is only output from the selected audio input source.
List of Functions
78
To Next Page
Loading...
