Submenu Function
Standby Setup
Standby Mode: You can use the following functions even when the projector is in standby mode if this is set to Communication
On.
• Monitor and control the status of the projector over the network.
You can use
SNMP
g
or the dedicated application software "EasyMP Monitor" to monitor and control the status of the projector over the
network.
• Output audio from the projector's speaker when a microphone is connected to the Mic input port.
*2
(Only when Standby Microphone is set to On.)
• Output audio from the projector's speaker for equipment connected to the audio input port.
*2
(Only when Standby Audio is set to On.)
Standby Microphone: (This can only be set if Standby Mode is set to Communication On.)
Set whether mic input is enabled (On) or disabled (Off).
Standby Audio: (This can only be set if Standby Mode is set to Communication On.)
Set whether audio input is enabled (On) or disabled (Off).
USB Type B
Set this to USB Display when the projector and a computer are connected with a USB cable and computer images are projected.
s Quick Start Guide
Set this to Wireless Mouse when the mouse pointer is to be operated by the remote control.
s
p.48
Set this to Off when using only Easy Interactive Function (EB-465i/455Wi only).
s
p.54
Language
You can set the Language to use for displaying messages and menus.
Reset
You can return the adjustment values for Display
*1
and Operation
*3
in the Extended menu to their default settings.
To return all menu items to their default settings, see s p.91
*1When User's Logo Protect is set to On in Password Protect, settings related to user's logo cannot be changed. You can make changes after setting User's Logo Protect to
Off. s p.50
*2 Audio is not output while Power On Protect from Password Protect is set to On.
*3 Except for "High Altitude Mode".
List of Functions
79
To Next Page
Loading...
