(3) Follow the on-screen instructions to install.
If the Start up and Launch Easy Interactive Driver options are displayed,
select them both.
* These two settings are not displayed in Mac OS 10.3.
(4) When "Finished" is displayed, the installer closes and Easy Interactive
Driver starts automatically.
q
• After installation is complete, if a screen is displayed prompting you
to reboot your computer, follow the on-screen instructions to reboot.
• When the setup program does not start automatically (Windows
only)
Select Start - Run to open the Run dialog box, type the letter for
your CD-ROM drive followed by :\EIDriverVxxx_Setup.exe, and
then click OK.
• When Easy Interactive Driver does not start automatically
For Windows
Select Start - Programs (or All Programs) - EPSON Projector -
Easy Interactive Driver Ver.x.xx.
For Mac OS
Double-click the Applications folder of the hard disk volume on
which Easy Interactive Driver is installed, and then double-click the
Easy Interactive Driver icon.
• When uninstalling Easy Interactive Driver
For Windows
Select Start - Settings - Control Panel - Add-Remove Programs or
Add or Remove Programs and then remove Easy Interactive
Driver.
For Mac OS
Run EIDriverVxxx_Uninstaller in the the hard disk volume on
which Easy Interactive Driver is installed.
D
Turn the projector on.
Check the following when images are not projected.
• Change the projector's input source to Computer1 or Computer2.
s p.21
• Change the output destination for the video signals on the
computer.
sComputer's documentation
Images are projected shortly after you make the changes.
Example of Changing Output
Epson
Macintosh Make mirroring settings
or perform display
detection. Depending on
the OS, the output can be
changed with
.
NEC
Panasonic
SOTEC
HP
Toshiba
Lenovo/IBM
SONY
DELL
Fujitsu
Computer
only
Screen only Both
On some computers, the
display state changes as
follows each time you press
the keys for changing the
output.
Easy Interactive Function (EB-465i/455Wi only)
57
To Next Page
Loading...
