Installing the Touch Unit
102
e
Drill holes in the installation surface, and then remove the template sheet
Make holes at the four points labeled as Main on the template sheet.
c
Depending on the condition of the installation surface, you may need to secure the bracket
at the points labeled as Sub.
Make holes at four points (two on the left and two on the right) for optimum balance.
f
Loosen the screws (x2) at the top of the Touch Unit Bracket
g
Slide the parts at the front of the bracket forward until they are fully extended
To prevent the sliding section from slipping during installation, lightly tighten the top screws (x2) that
you loosened in step 6.
To Next Page
Loading...
