Installing the Wall mount
30
Attaching the Mount
Determining the installation position (projection distance tables)
Determine the installation position of the wall plate according to the size of the screen (S) you want to project
on to. See the following figure to check the values from a to d. This is the value when the setting plate is in
the middle of the wall plate (See
in the following illustration).
The offset value for the center of the screen being projected and the center of the Wall Plate is 46.5 mm.
c
A shorter x distance may increase the minimum projection size.
46.5mm
S
a
c
d
b + x
x
a:
Minimum projection distance (Wide)
c:
Distance from the top edge of the image
to the bottom installation screw hole for
the wall plate
b + x:
Number on the arm slide scale on the set-
ting plate (maximum 533 mm)
d:
Distance from the top edge of the image
to the temporary screw hole for the wall
plate
x:
Distance from the wall to the projection
surface
(15 to 50 mm when using touch unit brack-
et ( p.14))
S:
Projected image size
To Next Page
Loading...
