Epson EB-G6970WU - The Image Is Truncated (Large) or Small, the Aspect Is Not Suitable, or the Image Has Been Reversed

Check Remedy
Are the
Sync. g and Tracking g settings adjusted correctly?
(Only when projecting computer images)
Press the [Auto] button on the Remote Control or the [
] button on the Control panel to perform automatic
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments from the Configuration menu.
s Signal - Tracking, Sync. p.109
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution p.109
The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed
Check Remedy
Have the Screen been set correctly? Make the appropriate Screen for the screen being used.
s "Screen Settings" p.27
Is the aspect adjusted correctly? Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image" p.72
Is a wide panel computer image being projected?
(Only when projecting computer images)
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.109
Is the image still being enlarged by E-Zoom? Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)" p.91
Is Scale set to On?Set Scale to Off on the configuration menu.
s Signal - Scale p.109
Is the image position adjusted correctly? (Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
] button on the control panel to adjust the position.
You can also adjust the position from the Configuration menu.
s Signal - Position p.109
Is the computer set for dual display?
(Only when projecting computer images)
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Problem Solving
137