Epson EB-G6970WU - Switching to the Target Image by Remote Control; Adjusting the Volume

Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
The input ports for each button are shown below.
Remote control
Input Port
F
EB-G6970WU only
Adjusting the Volume
You can adjust the volume for audio output from the Audio Out port using
one of the following methods.
• Press the [Volume] buttons on the remote control to adjust the volume.
[
a] Decreases the volume.
[
b
] Increases the volume.
Remote control
• Adjust the volume from the Configuration menu.
s Settings - Volume p.110
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume
before powering off, so that you can power on and then gradually increase the
volume.
a
When the source is SDI, no audio is output.
Projecting Images
50