Once the Configuration menu content has been set for one projector, you
can use it to perform batch setup for multiple projectors (batch setup
function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.
• Setup by connecting the computer and projector with a USB cable.
• Setup using EasyMP Network Updater.
This manual describes how to use the USB cable.
a
• The following content is not reflected by the batch setup function.
- The Network menu settings (except for the Mail menu and the
Others menu)
- Lamp Hours and Status in the Info menu
• Perform batch setup before adjusting the projected image.
Adjustment values for the projected image, such as Geometric
Correction are reflected by the batch setup function. If batch setup is
performed after adjusting the projected image, the adjustments you
made may change.
• By using the batch setup function, the registered User's Logo is set
for the other projectors. Do not register confidential information and
so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due
to a power failure, communication error, and so on, the customer is responsible
for any repair costs incurred.
Setup by Connecting the Computer and Projector
with a USB Cable
a
The following operating systems support the batch setup function.
• Windows Vista or later
• Mac OS X 10.5.3 or later
Saving settings to a computer
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the computer's USB port to the projector's Service port
with a USB cable.
Batch Setup
123
To Next Page
Loading...
Need help?
General
