c
While holding down the [Esc] button on the remote control or the
control panel, connect the power cord to the projector.
When all of the projector's indicators turn on, release the [Esc]
button.
Power supply Lamp Temp
Orange - On Orange - On Orange - On
The projector is recognized as a removable disk by the computer.
d
Open the removable disk, and save the batch setup file
(PJCONFDATA.bin) to the computer.
a
If you need to change the name of the batch setup file, add text
after PJCONFDATA. If you change the PJCONFDATA section
of the file name, the projector may not be able to recognize the
file correctly.
e
Perform "Remove USB device" on your computer, and then
disconnect the USB cable.
a
When using OS X, perform "Remove EPSON_PJ".
The projector enters standby status.
Batch Setup
124
To Next Page
Loading...
