Correction method
a
Press the [Menu] button while projecting.
b
Select Geometric Correction from Settings.
c
Select Curved Surface, and then press the [ ] button.
If the message "If this setting is changed, the image may be
distorted." is displayed, press the [
] button.
d
Select Correct Shape, and then press the [ ] button.
e
Use the [ ], [ ], [ ], and [ ] buttons to select the area you
want to adjust, and then press the [
] button.
When selecting a corner, you can adjust the two sides next to the
corner.
a
If the [Esc] button is pressed for approximately two seconds,
the confirm default reset screen is displayed.
Select Yes to reset the result of Curved Surface.
Adjusting Projected Images
59
To Next Page
Loading...
