c
Select Area Correction, and then press the [ ] button.
The points where you want to set the range for black level
adjustment are displayed.
The points are displayed to match the Top Edge/Bottom Edge/Right
Edge/Left Edge settings.
The number of points displayed on one side differs depending on the
adjustment method selected in geometric correction.
Example: When Left Edge is set and Point Correction (5x5) is
selected
d
Use the [ ], [ ], [ ], and [ ] buttons to select the point you
want to move, and then press the [
] button.
The selected point is displayed in orange.
e
Use the [ ][ ][ ][ ] buttons to move the point.
Multi-Projection Function
83
To Next Page
Loading...
