49
Parent topic: Attaching and Removing a Lens
Related references
Optional Equipment and Replacement Parts
Related tasks
Setting the Lens Type
Removing a Lens
You can remove a lens to replace it with a different lens.
Warning: Wait at least 30 minutes to remove or replace the lens after turning off the projector. Touching
the lens unit before it cools down may cause burns.
Caution: Remove the lens only when necessary and make sure the front of the projector is not facing up
when you remove the lens. This prevents dirt or dust from entering the projector and lowering the
projection quality. Avoid touching the lens with your bare hands to prevent fingerprints on or damage to
the lens surface.
1. Press and hold the Lens Shift (remote control) or Lens (control panel) button for approximately 3
seconds to move the lens to the center position.
2. Turn off the projector and unplug the power cord.
3. Pull the lens cover off of the projector.
To Next Page
Loading...
