Epson EB-S41 User Manual

Projector Lamp Maintenance
131
c
Use the screwdriver included with the replacement lamp to loosen the
screw securing the lamp cover.
Warning
When replacing the lamp, there is a possibility that the lamp may be
broken. If replacing the lamp of a projector which has been installed on the
ceiling, you should always assume that the lamp is cracked, and you should
stand to the side of the lamp cover, not underneath it. Remove the lamp
cover gently. Be careful when removing the lamp cover as shards of glass
may fall out and could cause an injury. If any shards of glass get into your
eyes or mouth, contact a doctor immediately.
d
Slide the lamp cover out and lift it off.
e
Loosen the screws securing the lamp to the projector. The screws do
not come all the way out.

Epson EB-S41 Specifications

General

Contrast Ratio	15, 000:1
Lamp Type	UHE
Keystone Correction	Vertical: ±30 degrees
Weight	2.5 kg
Projection Ratio	1.45 - 1.96:1
Screen Size	30 inches - 350 inches
Dimensions	302‎ x 237 x 82 mm (Width x Depth x Height)
Projection System	3LCD
Brightness	3, 300 lumens
Lamp Life	5, 000 hours (normal) / 10, 000 hours (eco)
Connectivity	USB 2.0 Type A, USB 2.0 Type B, VGA, HDMI, Audio in/out
Security	Kensington lock, Password protection
Color Modes	Dynamic, Presentation, sRGB, Cinema, Blackboard
Noise Level	37 dB (Normal) / 28 dB (Eco)
Native Resolution	SVGA (800 x 600)