Epson EB-S41 User Manual

Setting Up Monitoring Using SNMP
97
Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button on the control panel or remote control.
b
Select the Network menu and press [Enter].
c
Select Network Configuration and press [Enter].
d
Select the Notifications menu and press [Enter].
e
Set the SNMP setting to On.
f
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
a
Do not use these addresses: 127.x.x.x or 224.0.0.0 through
255.255.255.255 (where x is a number from 0 to 255). This
projector supports SNMP agent version 1 (SNMPv1).
g
Enter the SNMP Community Name up to 32 alphanumeric characters
long.
h
When you have finished selecting settings, select Complete and follow
the on-screen instructions to save your settings and exit the menus.

Epson EB-S41 Specifications

General

Contrast Ratio	15, 000:1
Lamp Type	UHE
Keystone Correction	Vertical: ±30 degrees
Weight	2.5 kg
Projection Ratio	1.45 - 1.96:1
Screen Size	30 inches - 350 inches
Dimensions	302‎ x 237 x 82 mm (Width x Depth x Height)
Projection System	3LCD
Brightness	3, 300 lumens
Lamp Life	5, 000 hours (normal) / 10, 000 hours (eco)
Connectivity	USB 2.0 Type A, USB 2.0 Type B, VGA, HDMI, Audio in/out
Security	Kensington lock, Password protection
Color Modes	Dynamic, Presentation, sRGB, Cinema, Blackboard
Noise Level	37 dB (Normal) / 28 dB (Eco)
Native Resolution	SVGA (800 x 600)