Epson EB-X31 User Manual

95
Setting Up Monitoring Using SNMP
Network administrators can install SNMP (Simple Network Management
g
When you have finished selecting settings, select Complete and follow
Protocol) software on network computers so they can monitor projectors. If the on-screen instructions to save your settings and exit the menus.
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button on the control panel or remote control.
b
Select the Network menu and press [Enter].
c
Select Network Configuration and press [Enter].
d
Select the Others menu and press [Enter].
e
Set the SNMP setting to On.
f
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
Do not use these addresses: 127.x.x.x or 224.0.0.0 through
255.255.255.255 (where x is a number from 0 to 255).
a

Epson EB-X31 Specifications

General

Projection Technology	3LCD
Resolution	XGA (1024 x 768)
Contrast Ratio	15000:1
Lamp Life Normal	5000 hours
Lamp Life ECO	10000 hours
Projection Ratio	1.48 - 1.77:1
Zoom	1.2x
Screen Size	30 inches - 300 inches
Weight	2.4 kg
Brightness	3200 lumens
Keystone Correction	Vertical ±30 degrees, Horizontal ±30 degrees
Inputs	HDMI, VGA, USB 2.0 Type A, USB 2.0 Type B, Composite
Output Ports	VGA
Security	Kensington lock, Password protection
Color Modes	Dynamic, Presentation, Cinema, sRGB, Blackboard