EasyManuals Logo

Epson EH-TW490 User Manual

Epson EH-TW490
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
From Installation to Projection
This section explains how to connect video equipment to the projector with
an HDMI cable and project images.
Attention
Make sure you connect the cable from the source to the projector first, and
then connect the power cord to the projector.
a
Connect the projector to the video equipment with an HDMI
cable.
b
Connect the projector to an electrical outlet with the power cord.
c
Turn on the projector.
d
Open the A/V mute slide.
e
Turn on the video equipment.
If the image is not projected, you can change the projected image using one
of the following methods.
Press the [Source Search] button on the control panel or the remote
control.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.29
Press the button for the target port on the remote control.
s "Switching to the Target Image by Remote Control" p.30
a
After projecting the image, adjust the image if necessary.
s "Correcting Keystone Distortion" p.34
s
"Correcting the Focus" p.39
When turning off the projector, press the [t] power button twice.
Projecting Images
28

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW490 and is the answer not in the manual?

Epson EH-TW490 Specifications

General IconGeneral
BrandEpson
ModelEH-TW490
CategoryProjector
LanguageEnglish

Related product manuals