Maintenance
73
Caution
•
Do not touch the lamp cover immediately after turning off the projector as it is still hot. Wait until the lamp
has cooled down sufficiently before removing the lamp cover. Otherwise, you could get burnt.
•
We recommend the use of genuine EPSON option lamps. The use of non-genuine lamps may affect projection
quality and safety.
Any damage or malfunction caused by the use of non-genuine lamps may not be covered by Epson's warranty.
a
Press the standby button on the
remote control or the control panel to
turn off the power, and then
disconnect the power cord.
b
Loosen the lamp cover fixing screw.
c
Remove the lamp cover.
Slide the lamp cover straight and remove it.
d
Loosen the two lamp fixing screws.
e
Remove the old lamp.
Grip the projection and pull it straight out.
f
Install the new lamp.
Make sure the lamp is facing the correct
direction and press it in.
g
Tighten the two lamp fixing screws.
To Next Page
Loading...
