Part Names and Functions
7
Rear (EMP-X5/S5 Only)
* Limited to computers with the following operating systems installed.
Windows 98/98SE/2000/Me/XP Home Edition/XP Professional
Macintosh: OS 8.6 to 9.2/10.1 to 10.3
Name Function
A
Remote receiver Receives signals from the remote control.
s Quick Start Guide
B
Speaker
C
Power inlet Connects to the power cable.
s Quick Start Guide
D
Monitor Out port Outputs the image signal from the computer
connected to the Computer input port to an
external monitor. This is not available for
component video
g signals or other signals
being input to any port other than the
Computer input port.s p.61
D
C
EGA
B
FIH
E
Computer input
port
For video signals from a computer and
component video
g signals from other video
sources.
F
Audio-L/R input
port
Connects to the audio output port for the
equipment you want to project from and inputs
the audio. s Quick Start Guide
G
Video input port
For composite videog signals from video
sources.
H
S-Video input
port
For S-videog signals from video sources.
I
USB port (Type B) When showing a slide show in PowerPoint,
you can use the projector's remote control to
move to the next slide/previous slide if it is
connected to a computer by a USB cable.
*
Also, you can use it as a control port when the
projector is controlled by a computer.
Even if the projector is connected to a
computer by a USB cable, you cannot project
the image on the computer. s p.63
Name Function
To Next Page
Loading...
