Projector Care-21
Appendices
Appendix.fm7/22/03
Replacing consumables
fReplacing the air filter
(Air filter: ELPAF04)
Replacing the air filter can also be performed when the projector is mounted to a ceiling.
1
Turn off the projector power, wait for
the cool-down period to end, then
disconnect the power cable.
Cool-downg takes about 20 seconds.
2
Put your finger into the latch and lift
off the cover. Lift up the air filter to
remove it.
3
Replace the air filter with a new one.
Take out the old air filter and install the new
one. Please ensure there are no gaps
between the air filter and the plastic grill.
4
Replace the air filter cover.
First insert the tabs, and then press down on
the opposite side until it clicks into place.
fChanging the battery
(Replacement battery: 1 × CR2025 lithium battery)
1
Remove the battery holder.
While pressing the catch of the battery holder
inwards, pull the battery holder out.
2
Remove the old battery and insert the
new one.
Check the position of the (+) mark inside the
battery holder to ensure that the battery is
inserted the correct way.
3
Replace the battery holder.
Press the battery holder in until it clicks.
p
Dispose of used air filters properly in accordance with
your local regulations.
c
Keep batteries away from children to avoid the risk of accidents.
If a child swallows the battery, contact your doctor immediately.
p
Please dispose of used batteries in accordance with
local waste disposal regulations.
USERS_E.BOOK Page 21 Tuesday, July 22, 2003 3:37 PM
To Next Page
Loading...
