Epson ET-M2120 Series - An Error Code is Displayed on the LCD Screen

The Root
Certicate
Needs to be Updated
The root certicate has expired.
Solutions
Run Web Cong, and then update the root certicate.
Cannot Cancel Printing from a Computer Running Mac OS X v10.6.8
There is a problem with your AirPrint setup.
Solutions
Run Web
Cong
, and then select Port9100 as the Top Priority Protocol setting in AirPrint Setup. Select
System Preferences from the Apple menu > Printers & Scanners (or Print & Scan, Print & Fax), remove
the printer, and then add the printer again.
& “Application for
Conguring
Printer Operations (Web
Cong
)” on page 212
An Error Code is Displayed on the LCD Screen
A code is displayed on the LCD screen if there is an error or information that requires your attention.
Code Situation Solutions
E-01 A printer error has occurred. Open the scanner unit and remove any paper or protective material
inside the printer. Turn the power
o
and on again.
E-02 A scanner error has occurred. Turn the power o and on again.
E-11 An ink pad needs to be replaced. Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
However, non-printing features such as scanning are available.
W-01 A paper jam has occurred. Remove the paper from the printer and press the button displayed on
the bottom of the LCD screen to clear the error. In some cases, you
need to turn the power o and on again.
W-11 An ink pad is nearing the end of its
service life.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be
displayed until the ink pad is replaced.
Press the
x button to resume printing.
I-22
Set Wi-Fi from the Push Button
(WPS).
Push the access point button. If there is no button on the access
point, open the access point setting window, and then click the
button displayed in the software.
I-23
Set Wi-Fi from the PIN Code (WPS).
Enter the PIN code displayed on the LCD screen into the access point
or computer within two minutes.
I-31
Set Wi-Fi from the Wi-Fi Auto
Connect.
Install the software on your computer, and then press the OK button
when Wi-Fi setup starts.
Solving Problems > An Error Code is Displayed on the LCD Screen
149