Epson Expression 800 - Page 63

Troubleshooting Page 63
The colors on the monitor seem different than the original image or printed image.
Some SilverFast Lite
settings may be set
incorrectly
Check your Tone Curves setting and/or select a darker Highlight setting.
See Adjusting Image Quality
for instructions.
Your monitor isn’t
calibrated or isn’t
adjusted correctly
Make sure you have calibrated your monitor to your scanner as
described in
Setting Up and Using Your Scanner . Also check your
monitor’s brightness and contrast settings.
Problem Solution
Your monitor may not
be calibrated correctly
Depending on your monitor, its resolution/color settings, and your
SilverFast Lite settings, the screen colors may be different from the
original colors. This may be normal, especially if the colors in the printed
image more closely match the original. Make sure you have correctly
calibrated the screen as described in
Setting Up and Using Your
Scanner .
Some SilverFast Lite
settings may be set
incorrectly
Check your Scan Type and Resolution settings to make sure they are
correct for the type of image you’re scanning and for the output device
you’re using. See Changing the Basic Settings
for instructions on
changing these settings.
If you used the Auto Adjust tool, you may have removed or retained a
color cast in the image. See Using Auto Adjust
for details on changing
the setting.
Problem Solution