Epson Expression Home XP-2200 Series

Light Status Solutions
Flashing simultaneously
An ink pad is nearing or at the end of its
service life.
The ink pads need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
*1
. It is not a user-
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights stop
ashing
for the time being, however, they will
continue to
ash
at regular intervals until the ink pad
is replaced.
Flashing alternately
A borderless printing ink pad is nearing or at
the end of its service life.
The borderless printing ink pad need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
*2
. It is not a user-
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights stop
ashing for the time being, however, they will
continue to
ash
at regular intervals until the ink pad
is replaced.
Borderless printing is not available, but printing with
a border is available.
The printer has started in recovery mode
because the rmware update failed.
Follow the steps below to try to update the rmware
again.
1. Connect the computer and the printer with a USB
cable. (During recovery mode, you cannot update the
rmware over a network connection.)
2. Visit your local Epson website for further
instructions.
A printer error has occurred. Open the scanner unit and remove any paper or
protective material inside the printer. Turn the power
o
and on again.
If the error continues to occur after turning the power
o and on again, contact Epson support.
*1 In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how oen
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs.
e
need for replacement of the pad does not mean that your
printer has ceased to operate in accordance with its specications. e printer will advise you when the pad
requires replacing and this can only be performed by an authorised Epson Service provider. e Epson warranty
does not cover the cost of this replacement.
*2 In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the product is designed to stop printing when the pad has reached its limit. Whether and how oen
Guide to the Control Panel > Checking Lights and Printer Status
22