Loading Pre-punched Paper
Load paper along the right side of the rear paper feeder with the printable side facing up.
❏ Load a single sheet of
dened
size plain paper with binding holes at the
le
or right.
❏ Adjust the print position of your le to avoid printing over the holes.
Related Information
& “Available Paper and Capacities” on page 147
& “Unavailable Paper Types” on page 149
Loading Long Papers
When loading paper longer than legal size, store the paper support, and then
atten
the leading edge of the paper.
❏ Make sure the end of the paper is cut perpendicularly. A diagonal cut may cause paper feed problems.
❏ Long paper cannot be held in the output tray. Prepare a box and so on to make sure that paper does not fall on
the oor.
❏ Do not touch paper that is being fed or ejected. It could injure your hand or cause print quality to decline.
Related Information
& “Available Paper and Capacities” on page 147
& “Unavailable Paper Types” on page 149
Loading Paper
>
Loading Various Paper
>
Loading Long Papers
29
To Next Page
Loading...
