4.
Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
Be careful not to touch the ink that has adhered inside the printer.
c
Important:
Wipe o the smear gently. If you press the cotton swab too hard to the lm, the springs of the lm may be
dislocated and the printer may be damaged.
5.
Use a new dry cotton swab to wipe the lm.
c
Important:
Do not leave any bers on the lm.
Note:
To prevent the smear from spreading, frequently replace the cotton swab with a new one.
6.
Repeat steps 4 and 5 until the lm is not smeared.
7.
Visually check that the
lm
is not smeared.
Cleaning the Printer
If the components and the case are dirty or dusty, turn o the printer and clean them using a so, clean cloth that
has been dampened with water. If you cannot remove the dirt, try adding a small amount of mild detergent to the
damp cloth.
Maintaining the Printer
>
Cleaning the Printer
70
To Next Page
Loading...
