E-11
Message:
Setup is incomplete. Conrm default gateway setup. Connection using the EpsonNet Setup is available. Contact
your network administrator for assistance.
Solutions:
Check the following.
❏ e default gateway address is correct if you set the printer's TCP/IP Setup setting to Manual.
❏ e device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
Related Information
& “Printing a Network Status Sheet” on page 29
E-12
Message:
Conrm the following -Entered security key/password is correct -Index of the security key/password is set to the
rst
number -IP address, subnet mask, or default gateway setup is correct Contact your network administrator for
assistance.
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ e network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
❏ e network addresses for other devices (subnet mask and default gateway) are the same.
❏ e IP address does not conict with other devices.
If still does not connect your printer and network devices aer conrming the above, try the following.
❏ Tur n
o
the access point. Wait for about 10 seconds, and then turn it on.
❏ Make network settings again using the installer. You can run it from the following website.
http://epson.sn > Setup
❏ You can register several passwords on an access point that uses WEP security type. If several passwords are
registered, check if the rst registered password is set on the printer.
Related Information
& “Printing a Network Status Sheet” on page 29
& “Connecting to a Computer” on page 18
User's Guide
Network Settings
28
To Next Page
Loading...
Need help?
General
