LQ-2180 Revision A
Product Description Operation Instruction 19
1.3 Operation Instruction
This section provides information on the LQ-2180 control panel buttons,
LED, and operations. Since the layout and functions of the control panel
are mostly common to those of LQ-2170, this section only shows the
information that is specific to LQ-2180. For other information, see LQ-
2170 Service Manual.
1.3.1 Control Panel
The control panel of this printer consists of the power switch, 6 non-lock
type buttons, and 10 LEDs. The appearance of the control panel is
shown in the figure below.
Figure 1-2. Control Panel
† Operation at power on
Turning on the printer while pressing panel buttons executes the
functions below:
Table 1-15. Operations at Power On
NOTE:The area reset by the EEPROM clear is as shown in the
next section. This operation, however, does not affect
such adjustment values as Bi-d adjustment and TOP
PE sensor adjustment.
1.3.2 Bi-directional Adjustment Function
In this mode, you can adjust the bidirectional alignment for the following
three modes:
1. Bi-directional adjustment for draft mode
2. Bi-directional adjustment for draft copy mode
3. Bi-directional adjustment for LQ mode
Draft
Rom an
Sans serif
C ourier
Prestige
Script
Others
Font
Pitch
10cpi
12cpi
15cpi
17cpi
20cpi
PS
T ear O ff/B in
Tear Off
Bin 1
Bin 2
Card
Pause
Micro Adjust
3sec.
Paper O ut
O p erate
LF/FF
Load/Eject
(1 )
(2 )
(3 )
(4 )
(5 )
(6 )
(7 )
No. Buttons Function
1 (5) LQ self test
2 (4) Draft self test
3 (2) Default setting
4 (4) + (5) Data dump
5 (1) + (3) EEPROM clear
6 (3) + (5)
Clear EEPROM for Driving Line count for
ribbon change timing
7 (6) Bi-d adjustment
http://www.4008109977.com guangzhou epson service :020-84207330
To Next Page
Loading...
