LQ-2180 Revision A
Product Description Specifications 9
1.1.3 Printing Specifications
† Copy capability: 1 original + 5 copies
† Printing speed and printable column (See the table below.)
Table 1-4.
Print Speed and Corresponding Printable Columns
NOTE:When the power supply voltage drops to the lower limit,
the printer stops printing and then resumes printing
remaining on that line more slowly than before.
NOTE:When the head temperature rises to the upper limit, the
printer stops printing. When the head temperature falls
to the normal level, the printer starts printing again more
slowly than before.
NOTE:The maximum printable width is 13.6 inch (345.44 mm).
1.1.4 Paper Handling
This section only describes the release lever setting, adjust lever
setting, and some other specifications which are specific to LQ-2180.
For the rest of the specifications, see the LQ-2170 Service Manual.
† Feeding method
„ Friction feed (front, rear)
„ Push tractor feed (front lever)
„ Push & Pull tractor feed (front, rear)
„ Pull tractor feed (front, rear, bottom)
† Feed speed
„ Normal mode: Same as for LQ-2180
„ Copy mode: 1/6 inch feed = 45 m sec
Continuous feed =0.092 MPW (m/second)
3.6 IPS (inches/second)
Printing mode Character pitch
Printable
columns
Printing speed (cps)
Normal Copy
High speed draft 10 cpi 136 480 320
Draft
10 cpi 136 360 240
12 cpi 163 431 286
15 cpi 204 539 358
Draft condensed
17 cpi 233 308 205
20 cpi 272 359 239
LQ
10 cpi 136 120 80
12 cpi 163 143 96
15 cpi 204 179 120
LQ condensed
17 cpi 233 204 137
20 cpi 272 238 159
http://www.4008109977.com guangzhou epson service :020-84207330
To Next Page
Loading...
