Epson LQ-2180 - Printing on Single Sheets; Loading Single Sheets and Special Paper

LQ-2180 Revision A
Product Description Operation Instruction 20
1.3.3 EEPROM Initialization
Areas reset by EEPROM clear operation (described in Section 1.3.1)
are as shown in the following tables:
Table 1-16. Initialization Area for EEPROM (1/2)
Table 1-17. Initialization Area for EERPOM (2/2)
No. Item Factory setting
1 Character table selection PC437
2 Page length (rear tractor) 11 inch
3 Page length (front tractor) 11 inch
4 Page length (CSF Bin 1) 22 inch
5 Page length (CSF Bin 2) 22 inch
6 TOF adjustment value (rear tractor) 8.5 mm
7 TOF adjustment value (front tractor) 8.5 mm
8 TOF adjustment value (CSF Bin 1) 8.5 mm
9 TOF adjustment value (CSF Bin 2) 8.5 mm
10
TOF adjustment value
(rear manual insertion)
8.5 mm
11
TOF adjustment value
(front manual insertion)
8.5 mm
12 Bottom margin (rear tractor) 11 inch
13 Bottom margin (front tractor) 11 inch
14 Font selection Roman
15 Pitch selection 10 cpi
16 Print direction setting Bi-D
17 I/F mode selection Auto
18 Auto I/F wait time setting 10 sec
19 Auto line feed Off
20 Auto tear off Off
No. Item Factory setting
21 Skip over perforation Off
22 High speed draft On
23 Input buffer On
24 Software ESC/P2
25 0 slash Off
26 Buzzer On
27 Roll paper Off
28 Auto CR (IBM) Off
29 A. G. M. (IBM) Off
30 Tear-off adjustment value 0 clear
31 Other font selection Roman T
32 Bin select
Friction Bin 1 or Tractor not Tear
off
33 Manual insertion wait time 2 or 3 sec.
34 Tear-off wait time 3 sec.
35 Copy mode Off
36 Black paper mode Off
37 Paper width measure On
38 TOF minimum value 4.2 mm
39 I/F timing data BUSY
40 Paper edge length 0 clear
41 Page length (rear manual insertion) 22 inch
42 Page length (front manual insertion) 22 inch
http://www.4008109977.com guangzhou epson service :020-84207330