1
Setting Up the Printer
1-13
Sun-E+
Rev. C
A5 size Chap1.fm
4/15/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
Plugging In the Printer
1. Make sure the printer is turned off. The printer is off when
the surface of the
Operate
button is even with the button
protectors as shown below.
2. Check the label on the back of the printer to make sure its
voltage matches that of your electrical outlet. Also make sure
the plug on your printer’s power cord matches your electrical
outlet.
c
Caution:
It is not possible to change the printer’s voltage. If the rated
voltage and your outlet voltage do not match, contact your
dealer for assistance. Do not plug in the power cord.
3. If the power cord is not attached to the printer, plug the
appropriate end into the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
G1-10.eps
To Next Page
Loading...
