2
Printing on Continuous Paper
2-13
Sun-E+
Rev. C
A5 size Chap2.fm
4/15/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
10. Make sure the printer is on. You may need to check and
change the printer driver settings as described in Chapter 4.
When the printer receives data, it automatically loads the
paper and starts printing. The printed pages are fed over the
paper guide toward the back of the printer.
11. After you finish printing, follow the steps in the next section
to tear off your printed document.
If the first printed line on your page appears too high or low,
you can fix this using the micro adjust feature as described in
“Adjusting the Top-of-Form Position” on page 2-36.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Removing the printed document from the front push
tractor
To remove the printed document, follow these steps:
1. Make sure the Tear/Off Bin lights are flashing. (This indicates
your paper is at the current tear-off position.) You may need
to press the
Tear Off/Bin
button to advance the paper to the
tear-off position.
2-35a.eps
To Next Page
Loading...
