A-10
Enhancing Your Printer With Options
Sun-E+
Rev. C
A5 size Appa.fm
4/15/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
Selecting the paper source (bin 1 or bin 2)
When the double-bin cut-sheet feeder is installed, you need to select the
paper source (bin 1 or bin 2) using your application or the printer’s control
panel. As shown below, the high-capacity cut-sheet feeder is bin 1 and the
second-bin cut-sheet feeder is bin 2.
It is best to select the paper source in your application program because
software settings usually override the printer’s control panel settings.
However, if you cannot select the paper source in your application, press the
Tear Off/Bin
button until the lights indicate the bin you want as shown
below. When the printer receives data, it automatically loads paper from the
bin you select.
bin 1: high-capacity
cut-sheet feeder
bin 2: second-bin
cut-sheet feeder
o n
Bin 1 (the high-capacity cut-sheet
feeder) is selected.
n o
Bin 2 (the second-bin cut-sheet
feeder) is selected.
n
= on,
o
= off
G4-17.eps
Panel.eps
To Next Page
Loading...
