3
Printing on Single Sheets
3-11
Sun-E+
Rev. C
A5 size Chap3.fm
4/15/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
3. Open the front paper guide by pulling the tab at the center of
the guide. Slide the left edge guide as shown below. (Printing
starts at the arrow mark.) Next adjust the right edge guide to
match the width of your paper.
4. Set the paper release lever to the single-sheet position. Also
set the paper thickness lever (located under the printer cover)
to the proper position for your paper’s thickness. (See the
table on page 3-3.)
5. Press the
Operate
button to turn on the printer, if necessary.
2-10a.eps
2-11nn.eps
To Next Page
Loading...
