4. Slide a sheet of paper down firmly between the edge guides
until it meets resistance. The printer loads the sheet and
begins printing automatically.
c
Caution:
Always close the printer cover while the printer is
printing. The printer cover helps the paper feed properly.
5. To stop printing temporarily, press the
Pause
button.
6. To end the self test, make sure the printer is not printing.
Press
LF/FF
to eject the sheet; then turn off the printer.
Here is part of a typical self-test printout:
Note:
If the self test did not print satisfactorily, see Chapter 3. If it prints
correctly, go on to the next section.
1-19
1-20
L
Blackberry REV.E
A5 size Chapter 1
96/04/08 pass 1
1-12
Setting Up the Printer
To Next Page
Loading...
