Installing and Using Options
Single-bin Cut-Sheet Feeder
The optional Single-bin Cut-Sheet Feeder (C80637
✽
) handles
up to 50 sheets of standard bond paper ( 82 g/m
2
or 22 lb)
without reloading. Follow these steps to install the cut-sheet
feeder:
1. Make sure the printer is turned off. Remove the paper guide.
2. If the tractor is installed in the pull-tractor position, remove
it and reinstall it in the push-tractor position.
3. Make sure the paper-release lever is in the single-sheet
position.
4. Hold the cut-sheet feeder in both hands and press on the
latch levers. Fit the notches in the cut-sheet feeder over the
mounting posts on the printer. Releasing the latch levers
locks the cut-sheet feeder in place.
2-17
R
Blackberry REV.D
A5 size Chapter 2
96/04/08 pass 1
Using the Printer
2-29
To Next Page
Loading...
