6.
On the underside of the printer cover, at each end of the control
panel, are two plastic retaining clips as shown in the diagram
below. Reach under the control panel and squeeze these clips
slightly to release the panel from the case.
Figure G-2. Removing the control panel
7.
Slip the control panel through the case and set the case to one side.
To replace the case, reverse the previous steps. Make sure that the
control panel connector has not been disconnected from the main cir-
cuit board. If it needs to be reconnected, the connector can only be
connected one way, so make sure that the arrangement of the holes in
the connector matches the pattern of pins on the circuit board. When
replacing the paper feed knob, make sure that the flat side of the shaft
is matched with the hole in the paper feed knob.
G-4
To Next Page
Loading...
