Adjusting the paper thickness lever
The LQ is equipped with a paper thickness lever that can be
adjusted to accommodate varying thicknesses of paper.
The lever is located in front of the paper release lever on the left side
of the printer as shown in Figure
1-10.
Figure 1-10. Paper thickness lever
When you receive your LQ, the lever is set for standard paper thick-
ness (about
1/500th
of an inch), with the small arm on the paper thick-
ness lever set in the notch shown in Figure
1-10.
For thicker paper or multiple copies, pull the lever toward the front
of the printer. To return the lever to the standard position, push it back
until it clicks into the standard setting.
5
Turning On the Power
With the ribbon and paper installed in the LQ, it’s time to turn
the printer on and become acquainted with the power-up sequence.
1-12
To Next Page
Loading...
