Epson LQ-800 - Installing the Tractor Unit; Continuous-Feed Paper Without Stand

Figure 3-2. Continuous-feed paper without stand
Installing the Tractor Unit
1. Remove the original dust cover that was included with your LQ.
Replace it with the front lid packaged with the tractor unit, and
leave it tilted up, as shown in Figure 3-3.
Figure 3-3. Installing the tractor unit
2. Hold the tractor with the gears to the right, and fit the rear notches
on the tractor unit over the rear mounting pins on the printer, as
shown in Figure 3-3.
3-2