Epson NX - Jumpers

Subassembly Descriptions
Jumpers
The location of each jumper is shown in Figure l-6. A jumper’s setting is determined by
where the jumper is placed on a set of pins. The jumper connects either pin A and the middle
pin or pin B and the middle pin. The jumper settings are defined in Table 1-9, Table l-10,
and Table l-11.
Table 1-9
System Board Jumper Settings (51-54)
Table l-10
System Board Jumper Settings (JS-J8)
Table l-11
System Board Jumper Settings (J9-515)
1-12 Epson NX Service Manual