Epson NX - Removing a Drive from the Horizontal Position

System Unit
8
Run the SETUP program immediately to update the computer’s configuration with the
new information.
Removing a Drive From the Horizontal Position
Follow these steps to remove a drive from a horizontal position:
1 Remove the computer’s cover (see page 3-2).
2
Remove the drive ribbon cable and the power supply cable from the back of the drive.
3
Remove the two front retaining screws securing the diskette drive to the chassis. Then,
gently pull the drive out from the front of the bay as shown in Figure 3-9.
Figure 3-9 Removing/Installing a Horizontal Drive
4
Keep the screws so that you can use them to install a drive later.
5 When removing the lower drive, replace the lower drive bay cover on the chassis and
on the front panel as shown in Figure 3-10.
6 If one of two hard disk drives is removed, the jumpers on the remaining hard disk
drive must be changed Check the hard disk drive documentation for details.
7
Replace the cover (see page 3-4).
8
Reconfigure the system with the SETUP utility before using the computer.
3-12 Epson NX Service Manual