Connector
Pin
Assignments
SMC Ether Card PLUS Elite16 Combo
The SMC EtherCard PLUS Elite16 Combo is a 16-bit, ISA-compatible Ethernet adapter card
that supports UTP, BNC coax (thin Ethernet), AUI DB-15s (thick Ethernet). The card is
software configurable for I/O address, IRQ, connector type, and I/O or memory-mapped
buffering. A diagnostic utility is included.
By default this card uses I/O address 280, IRQ3, and RAM base address D0000. You can
move jumper W 1, shown in the figure above, to SOFT to use the adapter setup program to
select the I/O address, IRQ, and RAM base address; or move it to 300, 10, CC000 to select
I/O address 300, IRQlO, and RAM base address CC000.
Table A-19
SMC EtherCard LEDs
A-26
Epson
NX
Service
Manual
To Next Page
Loading...
