Epson NX - Figure L-10 Jumper Placement for Hdds

Subassembly Descriptions
Conner CP-30174E
17O MB IDE HDD
Master = C/D jumpered
Slave = C/D not jumpered
Quantum LPS240AT
24OMB IDE HDD
Master = DS jumpered
Slave = not jumpered
(or if drive is configured
for cab/e selection using the
CS jumper, the drive is a
master drive if pin 28 is
grounded and a slave if
pin 28 is not grounded)
Quantum LPS525S
525MB SCSI HDD
See Table 1-19 for jumper
settings.
Figure l-10. Jumper Placement for HDDs
1-20
Epson NX Service Manual