System Unit
Removing the Option Slot Cover
Follow these steps to remove the option slot cover so you can install an option card:
1
Remove the cover as described on page 3-2.
2
Remove the retaining screw securing the option slot cover and slide out the slot cover
as shown in Figure 3-5. Keep the screw to secure the option card to the computer.
Store the slot cover in a safe place in case the option card is later removed.
Figure 3-5
Removing/Replacing the Option Slot Cover
Replacing the Option Slot Cover
Follow these steps to replace the option slot cover:
1
Remove the cover as described on page 3-2.
2
To replace the option slot cover, insert the cover as shown above in Figure 3-5 and
secure it with the retaining screw.
3
Replace the computer’s cover. (See page 3-4.)
3-6
Epson
NX Service
Manual
To Next Page
Loading...
