172 Software Installation
Mac System Requirements
Before you install the software, make sure your Mac meets the
following requirements:
■ Mac OS X 10.3 or later (OS X 10.3.9 or 10.4.5 or later
recommended)
■ AirPort (802.11b) or AirPort Extreme (802.11g) wireless network
interface to use EMP NS Connection wirelessly
■ Power Macintosh
®
series G3 900 MHz or more, iMac,
®
PowerBook,
®
or iBook
®
■ At least 256MB of RAM
■ At least 128MB of free hard disk space
■ XGA (1024 × 768) or better display adapter and monitor, 16-bit
color or higher
Installing the Software on a Windows
System
Follow these steps:
1. Insert the EasyMP CD-ROM in your computer’s CD-ROM or
DVD drive.
2. Click
Install, then follow the on-screen instructions to install
your projector software.
3. When you see the Virtual Display screen, check each display you
want to use. These correspond to the projectors you plan to
connect to the computer.
After you install the software, you can change your Virtual
Display selection by accessing
EPSON Projector from the Start
menu and selecting
Add-Remove EPSON Virtual Display.
To Next Page
Loading...
Need help?
General