Presenting Through a Wireless Network 57
Using Access Point Mode
To use Access Point (infrastructure) mode, first adjust your projector
and wireless access point or AirPort base station settings as described
in this section.
Configuring the Projector
1. Press the Menu button, then choose Network and press Enter.
2. Choose
Wireless LAN and press Enter.
You see this screen:
3. Make sure
Advanced is selected for the Connection mode. If
not, use the pointer button on the remote control to highlight
Advanced, then press Enter to select it.
4. If your network is using 802.11a, use the pointer button on
the remote control to highlight
802.11a, then press Enter to
select it.
5. To enable your computer to find the projector on the network,
you need to enter an ESSID, which is the SSID name of your
access point or the name of your AirPort network. (The name of
To Next Page
Loading...
