Why can't I select or change the connection mode in Epson EasyMP Network Projection?
If you are unable to select or change the connection mode, select 'Display Connection Mode Selection window on startup' on the General settings tab from Set options. The projector selection screen will then be displayed after restarting EasyMP Network Projection.
What to do if Epson software says I cannot start this application while USB Display is running?
If you receive the message that you cannot start the application while USB Display is running, close USB Display before starting EasyMP Network Projection.
Why are Epson applications no longer displayed from the computer screen when the multi-screen display function is executed?
If applications disappear from the computer screen when the multi-screen display function is active, it may be because EPSON Virtual Display is running another application on the virtual display. In this case, turn EPSON Virtual Display off in Screen properties.
Why is the Epson Slide Show not displayed on the desired display when the multi-screen display function is being executed?
If the Slide Show does not appear on the intended display while using the multi-screen display function, use PowerPoint 2003 or later, or limit the number of virtual displays to one before starting the Slide Show.
General| Contrast Ratio | 2000:1 |
|---|---|
| Lamp Life (Eco Mode) | 10000 hours |
| Projection System | 3LCD |
| Output Ports | VGA |
| Resolution | 1280x800 |
| Connectivity | HDMI, VGA, USB |
| Projection Size | 30 - 300 inches |
| Input Ports | HDMI, VGA, USB |
| Keystone Correction | ±30 degrees (Vertical), ±30 degrees (Horizontal) |
Allows projecting different images from one computer to multiple projectors simultaneously.
Enables projecting only the PowerPoint Slide Show, with a black screen otherwise.
Lists the system requirements for installing EasyMP Network Projection.
Provides step-by-step instructions for installing the software on Windows and Mac OS.
Details the two methods for connecting a computer and projector via network.
Guides on starting the application, selecting modes, and choosing a projector.
Search for projectors by specifying IP address or projector name in Advanced Connection Mode.
Procedure to set up virtual displays, including enabling drivers for Windows.
Troubleshooting steps for issues preventing connection to the desired projector.
Solutions for connection failures specific to Advanced Connection Mode.
Resolves problems with screens not projecting or images being slow to appear.
To Next Page