48 Connecting to Computers, Cameras, and Other Equipment
Connecting an RGB Video Source
1. Locate the VGA computer cable provided with the projector.
2. Connect the cable to the video port on your player and
the
Computer1 or Computer2 port on the projector.
3. You may need to change the
Computer1 Input or
Computer2 Input setting in the projector’s Signal menu
to
RGB (see page 142).
4. If you want to play sound through the projector, see page 50 for
instructions on connecting audio cables.
5. If you don’t need to make any other connections, see page 17 for
instructions on turning on the projector and adjusting the image.
Once the projector is turned on, select the image source: press the
Search button on the remote control or press the Source
Search
button on the projector’s control panel repeatedly until
the image appears.
note
Be sure your video player is
not a component video
source. If you select the
wrong source, image quality
may suffer. Check your
video player’s
documentation.
To Next Page
Loading...
Need help?
General