74 Presenting Through a Wireless Network
12. Click the
Wireless Networks tab. (If you don’t see this tab, you
may need to enable your wireless card or adapter by clicking
Configure to access the device settings; then follow any
instructions on the screen to enable the device.)
You see a screen like this:
13. Verify that you’ve enabled your computer’s connection to the
access point. It should be listed with the small icon next to it,
indicating a connection.
If it’s not listed, click
Configure and type the name of your access
point.
14. When you’re done making settings, click
OK to close the dialog
box.
Now you’re ready to connect to the projector. See “Projecting Over a
Network” on page 89.
To Next Page
Loading...
